If you count on a pool robot to maintain your pool in crystal clear condition, having issues with it is annoying. Regardless of whether you’re installing a new pool vacuum, setting up a skimmer, or deploying advanced robotic pool cleaners, you should know how to help the equipment work its best.
In this guide, we will discuss the common problems in pool cleaning robot systems, and solutions, so you could always have your vacuum cleaner for pool running at maximum efficiency.
Pump Not Working Or Starting in Or Around The Pool Or Spa
The most common problem with any robotic pool cleaner is that it won’t start or move. Begin by inspecting the power source, power cord, and power outlet. For plug-in models; Confirm that the pool booster-pump (if used) is on.
Also check that the filter basket is not full and that the motor is not clogged. Debris accumulation is a usual suspect, particularly if you use your robot pool in areas that have lots of leaves or fine silt.
Floating Robot or One that Does not Sink Correctly
If your pool vacuum robot floats instead of sticking to the pool floor, it may have trapped air. Insert it gently to allow the air bubbles to escape. Other causes might be misplaced or ill-fitting weights that balance the cleaner.
Also check to see if the internal components or filters are dirty or installed incorrectly, which can affect the cleaner’s buoyancy and performance.
Uneconomical Clean or Missed Areas
Is your automatic pool cleaner not covering all areas or leaving behind debris? Verify the smooth running of the navigation software. And some models, such as the Beatbot AquaSense 2 Ultra, Beatbot AquaSense 2 Pro, and Beatbot AquaSense 2, are smart enough to plan a path that ensures they don’t miss a spot.
Clogged sensors, tangled hoses or full debris baskets can also cause performance to suffer. If there’s no wall-climbing feature and yours isn’t reaching the tile line when it should, your machines’ brushes need to be cleaned and you may have to restore suction.
Algae Not Being Removed
A lot of pool owners have the same question: “Can a pool robot remove algae? Although most models can cope with light algae and dirt deposits, significant buildup may need to be brushed and/or pre-treated to remove before the robot is able to do its work.
If the algae is persistent try to clean the pool surfaces with acid wash first, then have the robotic cleaner do a run to catch any remaining stain. Moreover, by employing a specialized pool vacuum for algae you could even get better results.
Robot Is Not Moving or Keeps Stopping/Spinning in Circles
This is a common problem that is typically caused by hindrances in the pool, software malfunctions, or by mechanical malfunctioned goods. Get rid of floats, pool toys or ropes in the water. To boot, make sure the filters and impellers are clean of debris.
If your model allows it, reset the cleaner’s software. For premium brands like the Maytronics pool cleaner or Beatbot, updating the control unit or app can address navigation problems.
Drainage and Storage Tips
After using your robotic pool cleaner, make sure you rinse and dry it completely before putting it away. Discover how to drain an inground pool without a pump if you have to do some deep cleaning or pool repairs. Never leave your cleaner in the pool to store outside of the pool, is unnecessary wear and tear.
In Conclusion: Maintaining Your Robot Pool Cleaner And There You Have It!
A robot pool cleaner is an amazing investment — until it begins acting stupid. By learning how to diagnose the most common problems, like navigation issues, suction loss and algae removal, you can typically circumvent your robot pool cleaner from breaking down all season long. Units like the Beatbot AquaSense 2 Ultra with it’s big brother series are about as good as it gets with high levels of both performance and reliability needing little in the way of maintenance.
YOU MAY ALSO LIKE: How Often Should You Replace or Repair a Fence?
